CLOSET FINGER PULLS HOW TO
CLOSET FINGER PULLS INSTALL

Some door finger pulls will come with a self-adhesive back that makes them exceptionally easy to install, while other brands will require you to supply the adhesive. The tabs will hold it in place, and no other work is required. If your replacement finger pull uses tabs, you will only need to use a small hammer to tap it into position gently.

CLOSET FINGER PULLS INSTALL

If the finger pull is round, you might be able to install the screws from a different angle. If stripped or missing screws were the reason for the replacement, you might need to install longer screws to keep them from falling out again. Screws are the easiest because you will install the replacement and tighten the screws in the same place. Once you have the replacement, it is fairly easy to install it. Image Credit: Marco Zamperini, Shutterstock Sandpaper should work fine in most cases, and this is also the perfect job for a rotary sander if you have one. If the old finger pull used glue or you had to add wood glue, there is a good chance that you will need to sand the surface to make it smooth again to get it ready for replacement. Wood filler will help you create a smooth surface for your new finger pull to rest. If your finger pull was malfunctioning because of stripped screws or you noticed rotten wood behind it, you will need to fill it with a wood filler the best that you can. If the closet door is old or there was damage done to it, you will want to make repairs before you continue. Be patient, and use a hammer to gently tap the putty knife or pry bar to break the glue bond or lift the nails without causing much damage. The best way to remove these is to use a small putty knife or pry bar to lift them out gently. It’s also common for there to be tiny nails holding it in place. If you don’t see anything holding the finger pull in place, glue must be doing the trick. However, it will usually be easier to pry it out with a small pry bar, and doing so won’t result in any damage. In some cases, you might need to get a small flathead screwdriver, so you can pull the tab inward to remove the finger pull.

These tabs flex out of the way as you are pushing the finger pull into place but grip the wood so they won’t fall out. Some finger pulls have metal tabs built into the component to hold them in place. Offset screwdrivers are great at removing such screws. The screw might be at a difficult-to-reach angle, so you may need to try a few different screwdrivers. Many models will have one or two screws keeping it in place, so all you need to do is remove them, and the finger pull should fall out. Once you have all your tools, get started by removing the old closet finger pull.

CLOSET FINGER PULLS HOW TO

How to Replace a Closet Door Finger Pull (4 Steps) 1.

Closet finger pulls